Jump to content

Welcome to RennTech.org Community, Guest

There are many great features available to you once you register at RennTech.org
You are free to view posts here, but you must log in to reply to existing posts, or to start your own new topic. Like most online communities, there are costs involved to maintain a site like this - so we encourage our members to donate. All donations go to the costs operating and maintaining this site. We prefer that guests take part in our community and we offer a lot in return to those willing to join our corner of the Porsche world. This site is 99 percent member supported (less than 1 percent comes from advertising) - so please consider an annual donation to keep this site running.

Here are some of the features available - once you register at RennTech.org

  • View Classified Ads
  • DIY Tutorials
  • Porsche TSB Listings (limited)
  • VIN Decoder
  • Special Offers
  • OBD II P-Codes
  • Paint Codes
  • Registry
  • Videos System
  • View Reviews
  • and get rid of this welcome message

It takes just a few minutes to register, and it's FREE

Contributing Members also get these additional benefits:
(you become a Contributing Member by donating money to the operation of this site)

  • No ads - advertisements are removed
  • Access the Contributors Only Forum
  • Contributing Members Only Downloads
  • Send attachments with PMs
  • All image/file storage limits are substantially increased for all Contributing Members
  • Option Codes Lookup
  • VIN Option Lookups (limited)

Oil fill tube Q


Recommended Posts

My oil fill tube is cracked and I need to replace it? got the tube and know how to get the engine side

off and back on, but I can't tell if the tube connection to the rear trunk is clamped or not. I just can't seem to contort

myself to get a view -- or get a mirror down there to see.

2000 Boxster S

any help?

thanks,

Mike

Link to comment
Share on other sites

The tube is attached by a spring clamp. I had my transmission out when I replaced mine. I also removed the air tube from the intake box (where filter is) to the throttle body and the resonator too. This created room to get to the clamp from above.

IMG_0453.jpg

thanks for the picture -- might be easier to get to it from the trunk through the wire connector rubber grommet hole......

either way should be a good PITA!

thanks again,

Mike

Link to comment
Share on other sites

The tube is attached by a spring clamp. I had my transmission out when I replaced mine. I also removed the air tube from the intake box (where filter is) to the throttle body and the resonator too. This created room to get to the clamp from above.

IMG_0453.jpg

thanks for the picture -- might be easier to get to it from the trunk through the wire connector rubber grommet hole......

either way should be a good PITA!

thanks again,

Mike

Wow what a royal PITA!

Took me about 3 hours -- but I finally got it out and the new one back in.

From above you can get the engine side -- but the firewall side I had to

attack the clip from down below -- but I couldn't quite snag it -- was able to

do it once but couldn't move it --

I than attacked it from the engine wire harness hole.

Then a major tug of war to get it off....

Fortunately assembly was not the reverse of removal. It was much easier.

I made sure I aligned the clips in a way I could easily attach the spreader.

thanks for the picture tho -- as that helped me have the right game plan.

mike

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.