Jump to content

Welcome to RennTech.org Community, Guest

There are many great features available to you once you register at RennTech.org
You are free to view posts here, but you must log in to reply to existing posts, or to start your own new topic. Like most online communities, there are costs involved to maintain a site like this - so we encourage our members to donate. All donations go to the costs operating and maintaining this site. We prefer that guests take part in our community and we offer a lot in return to those willing to join our corner of the Porsche world. This site is 99 percent member supported (less than 1 percent comes from advertising) - so please consider an annual donation to keep this site running.

Here are some of the features available - once you register at RennTech.org

  • View Classified Ads
  • DIY Tutorials
  • Porsche TSB Listings (limited)
  • VIN Decoder
  • Special Offers
  • OBD II P-Codes
  • Paint Codes
  • Registry
  • Videos System
  • View Reviews
  • and get rid of this welcome message

It takes just a few minutes to register, and it's FREE

Contributing Members also get these additional benefits:
(you become a Contributing Member by donating money to the operation of this site)

  • No ads - advertisements are removed
  • Access the Contributors Only Forum
  • Contributing Members Only Downloads
  • Send attachments with PMs
  • All image/file storage limits are substantially increased for all Contributing Members
  • Option Codes Lookup
  • VIN Option Lookups (limited)

Replace the convertible top latch switch?


Recommended Posts

Howdy all,

I've read a few posts on here that tell me I'm not alone in the Boxster crowd when I drive over a bump in the road and my windows decide to lower halfway because the car thinks the top is being activated. The wife does not really appreciate this little feature while we're driving.

To get the windows to raise again, I just have to disengage the latch and re-engage it to make sure the latch goes far enough into the hole to press down the button again.

A couple of questions for folks:

1) Is the correct part to replace the "Convertible Top Latch Switch" that goes in the center between the visors?

2) Does anyone that's replaced it have any instructions they could share?

Link to comment
Share on other sites

  • Moderators

Pull out the 2 oval covers for the interior motion detector and behind them you will see 2 torx screws, remove the screws. Then pull the top latch housing away and disconnect the electrical connector.

The switch is held in place with 2 round clips. Pry the clips off and then the switch comes off. You cannot reuse the clips so buy them when you buy the switch.

Or, the no cost way is to glue a shim to the button that gets pressed when the top is latched and see if that cures the issue.

post-4-1109022996_thumb.jpg

Link to comment
Share on other sites

  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.