Jump to content
×
×

 

The RennTech.org community is Member supported!  Please consider an ANNUAL donation to help keep this site operating.
Click here to Donate

Welcome to RennTech.org Community, Guest

There are many great features available to you once you register at RennTech.org
You are free to view posts here, but you must login to reply to existing posts, or to start your own new topic. Like most online communities, there are costs involved to maintain a site like this - so we encourage our members to donate. All donations go to the costs operating and maintaining this site. We prefer that guests take part in our community and we offer a lot in return to those willing to join our corner of the Porsche world. This site is 99 percent member supported (less than 1 percent comes from advertising) - so please consider an annual donation to keep this site running.

Here are some of the features available - once you register at RennTech.org

  • View Classified Ads
  • DIY Tutorials
  • Porsche TSB Listings
  • VIN Decoder
  • Special Offers
  • OBD II P-Codes
  • Paint Codes
  • Registry
  • Videos System
  • and get rid of this welcome message

It takes just a few minutes to register, and it's FREE

Contributing Members also get these additional benefits:
(you become a Contributing Member by donating money to the operation of this site)

  • No ads - advertisements are removed
  • Access the Contributors Only Forum
  • Contributing Members Only Downloads
  • Send attachments with PMs
  • All image/file storage limits are substantially increased for all Contributing Members
  • Option Codes Lookup
  • VIN Option Lookups (limited)

Recommended Posts

Dear Sir and Madame, 

Could you please kindly advise me where can I find replacement LCD monochrome display for my Carrera 997 A/C control.

Unfortunately, it was damaged while replacing the control buttons. 

I have the precise dimensions of this display (screen). 

Thank you very much!

Alexander L.

 

Share this post


Link to post
Share on other sites
    You can remove these ads by becoming a Contributing Member.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

    • By Special
      Had a puddle when warm, from the drivers side front (coolant leak as discoloured the drive). 
      Common problem so took the wheel off with it facing as far right as possible, then, If I recall, 7 screws to remove the plastic cover of the inner wheel arch (torxs)
      Bottom of the 2 pipes were the problem on mine
      The 2 ends of the pipe means you will need a big bucket to catch all the fluid,
      There will be a something like a 3mm wire cir-clip that retains the hose, one at each end, make sure it is well clear or take it off all together, its easy to get back on.
      then just pull the hose off and get wet.(image)
      The leaking end had been bodged before so was I had to wiggle for a while, don't forget the car is on jacks so don't pull too hard.
      then release the other end, I must have releases a good 3 litres of coolant out of the car.
      The new hose (image) is apparently silicone based, and I read that you are not to use silicone lubricant on silicon hoses?
      So you will have to decide on what to put on the hose to aid insertion.
      Clean everything as much as you can, then push the new hose and put back the clips on both ends (test pull to see if well located).
      With the Gen2 (might be cayman and boxster the coolant refill should be done with a full drain as per other tutorials, but to refill and bleed you have to remove the engine cover and find the 
      bleed valve as per image. not in the boot as gen1( as I understand)
      Check for leaks




    • By ocmacman
      I recently purchased some used radiator air ducts for my 2006 C2S. The airducts looked great and no broken clips in the photo and when I spoke to the seller. However when the air ducts arrived some of the clips where you slide the air ducts onto the radiator were broken. I did see where the seller tried to tape them up to protect them so I can't blame the seller. The post office I can blame.
       
      Well has anyone ever repaired their air ducts clips? If so how did you do it? Bodyshop maybe? plastics fabricator? I hate to have to buy two more of these.
       
      ocmacman
    • By kjbu
      Hi
       
      Anybody have the Cayenne 2004 workshop/repair/service manual in PDF-format?
      Possible to "borrow" it? That would be very happy :thumbup:
       
      Please PM if you don't want to reply in this thread.
       
       
      There are a lot of places on the internet to buy the manual, but don't know the quality of these. Have read people have had mixed experiences with these. The "original" should have at least 9700 pages.
       
      Best regards,
      Kjetil, Norway
       
    • By 2seatcollector
      I'm trying to remove the heater control on my 2002 986, so I can replace the malfunctioning LCD.  Since the failure of these older LCDs (the radio has the same issues) is such a common problem, I thought there might be a tutorial here, to review, before I go prying away at the dash.  But I haven't been able to find one by doing a simple "Heater Control Removal" search.  Can anyone enlighten me with a link or the smoothest removal procedure?  Spring is almost here, so I need to fix this for driving!  
       
      Also looking for the easiest way to replace the partly defective display on the Becker Radio LCD.  The 2002 has the security radio with the plug-in display, so at least this is easy to remove.  Wondering if anyone has had a successful repair done on their Becker radio display, for less than an arm and a leg?
       
      Thanks!
    • By dupleix
      Hi everyone
       
      i'm willing to display elevation on the multi function display - see attached picture (top gear magazine)

       
      unfortunately I don't see elevation (altitude) as being one of the option available when customizing the 4 filelds of the display.
       
      i have PCM, satnav and sport chrono options... and I can display altitude on the main PCM screen.. 
       
      anybody knows why I can't do it on the multi function display ? 
       
      thanks !
       
       
       
       
       
×