Jump to content
×
×

Welcome to RennTech.org Community, Guest

There are many great features available to you once you register at RennTech.org
You are free to view posts here, but you must log in to reply to existing posts, or to start your own new topic. Like most online communities, there are costs involved to maintain a site like this - so we encourage our members to donate. All donations go to the costs operating and maintaining this site. We prefer that guests take part in our community and we offer a lot in return to those willing to join our corner of the Porsche world. This site is 99 percent member supported (less than 1 percent comes from advertising) - so please consider an annual donation to keep this site running.

Here are some of the features available - once you register at RennTech.org

  • View Classified Ads
  • DIY Tutorials
  • Porsche TSB Listings
  • VIN Decoder
  • Special Offers
  • OBD II P-Codes
  • Paint Codes
  • Registry
  • Videos System
  • and get rid of this welcome message

It takes just a few minutes to register, and it's FREE

Contributing Members also get these additional benefits:
(you become a Contributing Member by donating money to the operation of this site)

  • No ads - advertisements are removed
  • Access the Contributors Only Forum
  • Contributing Members Only Downloads
  • Send attachments with PMs
  • All image/file storage limits are substantially increased for all Contributing Members
  • Option Codes Lookup
  • VIN Option Lookups (limited)
Sign in to follow this  

Reset 'Service Now' Message - Durametric


Description

How to get rid of the service now message on your speedo
I know this is a super simple one, but I have seen many inquiries with plenty of people saying this is not possible.  So thought to provide accurate steps.
In case you need to reset that pesky message appearing on your speedo, telling you to service your car now, do the following. I have been doing this via Durametric, with 100%
success rate so far.
Durametric sw ver: 6.5.2.0

- Connect cable to ODB2 port in car, and other end of cable into powered on laptop
- Start Durametric SW
- IF asked to choose your year/vehicle, do so and click OK to proceed
- Click the + sign next to Instrument Cluster section to expand it
- Highlight the 'Commands' section
- On right side of window, you will see prompt is you want to reset the service message.
- Click reset, wait for completion message, click OK to close window and close Durametric.

Done.
 


×

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.