Server Lease Renewal/Software Licenses
Our yearly server lease, software licenses, as well as hardware operating costs, WERE due Dec 6th, 2021. Our current donations have fallen far short of the funds we need to renew. Please remember the RennTech.org community is Member supported so please consider a donation to help... THANK YOU!
Welcome to RennTech.org Community, Guest
Search the Community
Showing results for tags 'double din'.
I have a PCM 1 coupled to a HAES 6x40 amp. I want to replace the PCM1 with a Parrot Asteroid Smart. The area where the unit fits has a cup holder which I have been taold is a problem in itself. I have located a facia and wiring kit from Euro Motorspeed but I have been told that because the Parrot is a 4 channel and the amp is 6, I am unable to link thme together! Any one with any ideas?/ I
Hello all, I bought my first Porsche 2 months ago - a 2006 Porsche Boxster S with 40k miles on it. The previous owner had a custom headunit installed professionally - he had them put in a Pioneer AVH-X8500BHS and they routed an iPhone 30pin connector to the center armrest console. Obviously this connector is out of date now and I would like to replace it with a Thunderbolt cable and do some other work. The problem I am having is that I did not receive the instruction manual for the double-din dash kit and cannot figure out how to remove the dash kit brackets to get to the back of the headunit. I don't know what brand the dashkit is but I have seen it in a few screenshots from other people on the forum so it must be fairly common. Here are some screenshots of what I am looking at: Front Overview: http://www.renntech.org/forums/uploads/downloadedimages/q3vh9dd.jpg Lower Right Corner: http://www.renntech.org/forums/uploads/downloadedimages/pvxwevj.jpg Top Right Corner: http://www.renntech.org/forums/uploads/downloadedimages/4sdyb4f.jpg Left Front: http://www.renntech.org/forums/uploads/downloadedimages/usj8hfg.jpg Left Side: http://www.renntech.org/forums/uploads/downloadedimages/e0rtauf.jpg Close-up of the brackets the headunit is mounted to in order to fit the original PCM-sized slot: http://www.renntech.org/forums/uploads/downloadedimages/ocryhw8.jpg I spent about an hour and a half trying to pull and pry the unit out. Pure force was not yielding any progress, so there must be some screws or clips. I can't see any visible screws on the sides that would be holding the headunit in the bracket, and the only clips I see are the four metal clips on the front of the brackets. I've tried pulling outward and inward on them with no results. Does anyone have any experience with these brackets? How do I remove the headunit? I just need to slide it out so that I can plug in some additional cables to the back ports of the radio. Thank you.
Neb33 posted a topic in 996 Series (Carrera, Carrera 4, Carrera 4S, Targa)Hi everyone, So I have been doing some research before I attempt to install my own radio. I have a 2003 C4S with a MOST system, but non bose. So I have to install 4 wires from the head unit to by pass the amp in the trunk. I can not seem to find a good way to enter the trunk. I have attached some picture, and here is where the harness and optical cable enters the trunk. It looks very tight, how do I put more wires through the gromet? Should I drill the gromet? The red arrow is where the tunnel through the firewall is. Please advise! Thanks !