Welcome to RennTech.org Community, Guest
Search the Community
Showing results for tags 'retrofit'.
I want to add the OBC functionality to my MY1999 manual C2 and have been gathering information in preparation, mainly from this great forum. I still have a couple of queries.. I'm aware that I need the OBC enabled at a dealer or similar first, which ever route I go. I understand the 'one-button' hack and how to install that, probably in a spare dash position. I was though thinking of replacing my two-stalk indicator assembly with a suitable three-stalk one. If I do this, is it simply plug'n'play, or do I still have to hack into the dash connectors? On a recent visit to my OPC, I asked them to enable the OBC, so I could at least have the temperature displayed. They said that this was only possible on certain cars, and even then only on certain instrument clusters, looked at my car and said it wasn't possible.. Anyone heard of this? I thought it was possible on all pre-2001 cars with air-con (external temp sensor fitted)... Thanks as always.
Can any one assist with determining if it is possible to retrofit Park Assist into a Mk1 996 GT3? I understand the control module is under the left seat, there are 4 sensors in the rear bumper and the wiring will need to be run from the cabin to the rear as it will not be in situ. if I understand the ECU (?) will need to be set for Park Assist, my first question is can the Mk1 GT3 ECU (?) handle Park Assist? Thank you, Great Site. I am not yet convinced that i want to depart from an original spec, but parking will be tight end to end in the garage. I will use a bump stop on the floor as I reverse in and the aural warning would be extra protection.