Server Lease Renewal/Software Licenses
Welcome to RennTech.org Community, Guest
1999 986 2.5 Boxster. (5 spd)
Not many problems with the car but cruise control doesn’t work and the spoiler only extends halfway or so.
Current actual problem with the car is that I can feel vibration or shaking in the steering wheel (and in the car to a much lesser extent) after shifting into fourth gear. After shifting into fourth gear, the shaking seems to persist even as I slow down, or after shifting into fifth. It will persist even if I shift into neutral but will stop after I come to a stop.
It’s strange to me that this is the case when gears 1-3 don’t have this problem. I am guessing that it’s an issue with bearings or alignment in the front wheels since i’m feeling the vibrations in the wheel but hopefully someone here has a better idea.
Tried googeleing it but couldn’t find what I was after. Was curious if anyone knows what type of flat 6 the 986 boxster has?
Is it a a true boxer engine? Or a horizontally opposed flat V? True boxer meaning it has individual crank pins for each piston and is a true 180degree angle. Thanks in advance
I'm new to the Porsche family.... Just over a month and the proud owner of a 1999 Boxster. It's a project car but still on the road and my point to point ride. Must say, LOVE to drive this car....This one has been lowered some, well alot... and does it hug the road..... Just doesn't miss much being that low.... My question is, I am having an issue with the rear lights on this car... I know I had a problem with the left rear brake light. I tried tracing back the wire but found no problem... I then switched the lamp holder from the right side to the left and all the lights worked... So I thought I had an equipment issue. I bought a (Porsche) replacement bulb holder. Came in last night. Changed out today...Guess what???? Turn indicators work, Backup lights work, Brake light works on the Right Side ONLY, (still) Now no rear tail lights what so ever......I have checked ALL the fuses, only had to replace one and it had nothing to do with the lights. NOTHING has changed....Where did my tail lights go?????? Can't figure this out.......Please help.......Just FYI, ALL the LIGHTS were working as of last Wed. when I did the bulb holder swap and checking the lights. Power is to both wire harnesses. Everything else works except the left brake light and the drive lights. Go figure.......
I'm new to this website. Here is a question:
I have a 1998 Boxster 2.5 Tiptronic. I just had a new key programmed at dealership ( the old key fob newer worked). With new key fob, all doors (including gas) lock and unlock appropriately. However, when pressing the button to open the rear trunk lid, the lid doesn't move and the rear lock actuator/solenoid is silent. I disconnected the actuator from the car (separating the plastic connector) and using a 9v battery, made the actuator ( and lock) open and close. So I believe the problem is not the actuator. I also connected a volt meter to the two wires that connect from the car to the actuator, then pressed the fob button, and no voltage was recorded. However, the red light on the fob and the red light on the dash near the windshield did light up
So i believe the problem lies in the electrical system somewhere between the actuator and the fob. Any ideas on how to test the wiring running from the trunk lock actuator to the CLU? immobilizer? or wherever it goes? Or should I be spending my time evaluating the CLU? immobilizer? ??
Thanks for any advise!