Welcome to RennTech.org Community, Guest
For anyone wanting to know how to remove the front and rear seats as well as the front driver/passenger seatbelts... this is the video for you! 😎 It was fun trying to figure out how to do this. Hopefully this helps anyone trying this. I would say removing the seats is 2/10 for difficulty, the side panels maybe 7/10 and then ultimately the seatbelts themselves a solid 5/10. Hope this helps! Should be more or less the same for the 996 and 997.
Seats and Seat Belts Removal DIY for the Porsche 911:
Does anyone have a wiring diagram for the seat on a 2008/957 Cayenne which they can let me have?
I’m trying to chase a fault where the passenger seat will motor up and down and the backrest will adjust forward and aft, but there is no response from the controls to move the seat unit forwards and backwards, or the four-way lumber support control.
Thanks in anticipation...
My 2002 996 coupe has a squeaking passenger seat when I push/pull the top or back part of the seat, including driving over bumps. I have half powered seats,,, the top/back is powered while the lower seat assembly is manual. The squeak happens when the top/back is in any position including up so you can access the back seats.
Something must be loose, but my question is if there are any DIY instructions that I could focus on instead of trying to tighten every bolt and hex screw that I can access. It's pretty compact down there...
Thank you in advance