Jump to content

Welcome to RennTech.org Community, Guest

There are many great features available to you once you register at RennTech.org
You are free to view posts here, but you must log in to reply to existing posts, or to start your own new topic. Like most online communities, there are costs involved to maintain a site like this - so we encourage our members to donate. All donations go to the costs operating and maintaining this site. We prefer that guests take part in our community and we offer a lot in return to those willing to join our corner of the Porsche world. This site is 99 percent member supported (less than 1 percent comes from advertising) - so please consider an annual donation to keep this site running.

Here are some of the features available - once you register at RennTech.org

  • View Classified Ads
  • DIY Tutorials
  • Porsche TSB Listings (limited)
  • VIN Decoder
  • Special Offers
  • OBD II P-Codes
  • Paint Codes
  • Registry
  • Videos System
  • View Reviews
  • and get rid of this welcome message

It takes just a few minutes to register, and it's FREE

Contributing Members also get these additional benefits:
(you become a Contributing Member by donating money to the operation of this site)

  • No ads - advertisements are removed
  • Access the Contributors Only Forum
  • Contributing Members Only Downloads
  • Send attachments with PMs
  • All image/file storage limits are substantially increased for all Contributing Members
  • Option Codes Lookup
  • VIN Option Lookups (limited)
BobbySpeed

Car still doesn’t start- dried out and new battery

Recommended Posts

2006 V6 Cayenne 100k mi.

My car died at the train station but my son was able to jump start me. I drove the car home and it hasn’t started since. That was May. I did a lot of reading on the forum and I pulled up the drivers carpet and the padding was wet, so I unwrapped the wire bundle, opened all the doors and windows, disconnected the battery, hung the carpet from the steering wheel and let Mother Nature dry the car out.

The ends of the spliced wires were heavily corroded so I cut them back a little and rejoined them. After doing the wires my brake proportioning and lock fault messages disappeared. The lights, radio, a/c all work, but I hear nothing else- silence from my dead car. I checked all the fuses- right and left sides, and under the hood. The ground connection is fine. The 5A fuse under the driver seat is fine as well.

 

The car didn’t start so I hooked up the Durametric:

Vehicle Electrical System- 907 fault.

Gateway- 532, 1314, 1321

 

So, I pulled the battery and the parts store exchanged it because it had a dead cell. It was getting dark out, and dinner was getting cold, but I put the battery in place and connected the cables. Lights, radio, a/c all work, but car still doesn’t start. No bad starter sounds, nothing. I can shift into neutral like normal.

 

I cleaned up the cowl area and the drains are now clearer, checked my A/C drain and it’s clear. The passenger front sunroof drain has some water in it and I cannot pass a line from my weed trimmer/whacked all the way through- I took off the wheel and removed the wheel liner for full access. I tried sucking out any blockage with my shop vac to no avail.

2006 V6 Cayenne

Share this post


Link to post
Share on other sites
    You can remove these ads by becoming a Contributing Member.

... and how do you remove the 433 relay under the seat? I want to test it without breaking it.

Edited by BobbySpeed
Clarification

Share this post


Link to post
Share on other sites

Just pull it out, then open it with a screw driver and then press it back in and watch if it clicks then you turn the ignition on. Or replace it with the 433 relay from the starter.

 

In nearly got the same problem but my relay under the driver seat is fine. 

Share this post


Link to post
Share on other sites

Then it should be fine.

Under the passenger carpet is 1 spliced cable you checked this too?

In the fuse box under the hood are also spliced wires under the fuse/relay tray.

I hope you checked all the fuses driver und passenger side dash, under the seat and under the hood.

Share this post


Link to post
Share on other sites

Checked all the fuses, but will look at thise other spliced wires.

The strands of the black wires in the picture when cut back are very grey.

B617E6B1-7BF5-4169-87B7-077395976CF2.jpeg

Share this post


Link to post
Share on other sites
On 9/1/2018 at 8:23 PM, BobbySpeed said:

Checked all the fuses, but will look at thise other spliced wires.

The strands of the black wires in the picture when cut back are very grey.

B617E6B1-7BF5-4169-87B7-077395976CF2.jpeg

 

Keep cutting back until you get to shiny copper color. The gray are corroded wires - caused by water being drawn up into the wire by capillary action.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.