Welcome to RennTech.org Community, Guest
There are many great features available to you once you register at RennTech.org
You are free to view posts here, but you must log in to reply to existing posts, or to start your own new topic. Like most online communities, there are costs involved to maintain a site like this - so we encourage our members to donate. All donations go to the costs operating and maintaining this site. We prefer that guests take part in our community and we offer a lot in return to those willing to join our corner of the Porsche world. This site is 99 percent member supported (less than 1 percent comes from advertising) - so please consider an annual donation to keep this site running.
Here are some of the features available - once you register at RennTech.org
- View Classified Ads
- DIY Tutorials
- Porsche TSB Listings (limited)
- VIN Decoder
- Special Offers
OBD II P-Codes
- Paint Codes
- Videos System
- View Reviews
- and get rid of this welcome message
It takes just a few minutes to register, and it's FREE
Contributing Members also get these additional benefits:
(you become a Contributing Member by donating money to the operation of this site)
- No ads - advertisements are removed
- Access the Contributors Only Forum
- Contributing Members Only Downloads
- Send attachments with PMs
- All image/file storage limits are substantially increased for all Contributing Members
- Option Codes Lookup
- VIN Option Lookups (limited)
Recently I had been noticing issues with my cooling system the coolant temp guage would go past the 0 on 180 and I wouldn’t hear fans or anything. (Already tested fans and resistors and relays). The temperature Will continue to creep up if I sit still, with no signs of fans, AC OFF.
I replaced the coolant temp sensor. Problem fixed!! Then same issue again it seems after a week of driving.
Now i currently have ordered another temp sensor just Incase I maybe did something to cause the other new one too fail, I’ll be changing it again today.
However I was doing the climate control hack to check my actual temperatures today while doing a short troubleshooting drive. And I noticed my oil temperature said 0, which is physically impossible 🙄
Is it possible the oil temp guage is throwing off the coolant sensor? Is it even possible for the oil temp sensor too go bad but not the oil level sensor? (They are a 2 in 1 sensor)
THANK YOU IN ADVANCE
By Alan Huey
I recently had to replace the water pump on my 2001 Boxster. This all went fine, however, the red light to the right of the temperature gauge is blinking at 1 Hz. I've read this indicates low coolant level. I followed the factory procedure to bleed the system and it is filled to the max, but the light still blinks. Also, the gauge is flatlined to the left. I replaced the temperature sensor near the #4 cylinder head without improvement, and the wires "look" ok. All the fuses are good. Does anyone know the procedure to troubleshoot this wiring? Or the pin and socket numbers for the wiring diagram? The temperature gauge worked fine before the water pump blew up. I did recover most of the impeller, but a few small pieces are in there.