Jump to content
×
×

Welcome to RennTech.org Community, Guest

There are many great features available to you once you register at RennTech.org
You are free to view posts here, but you must log in to reply to existing posts, or to start your own new topic. Like most online communities, there are costs involved to maintain a site like this - so we encourage our members to donate. All donations go to the costs operating and maintaining this site. We prefer that guests take part in our community and we offer a lot in return to those willing to join our corner of the Porsche world. This site is 99 percent member supported (less than 1 percent comes from advertising) - so please consider an annual donation to keep this site running.

Here are some of the features available - once you register at RennTech.org

  • View Classified Ads
  • DIY Tutorials
  • Porsche TSB Listings (limited)
  • VIN Decoder
  • Special Offers
  • OBD II P-Codes
  • Paint Codes
  • Registry
  • Videos System
  • View Reviews
  • and get rid of this welcome message

It takes just a few minutes to register, and it's FREE

Contributing Members also get these additional benefits:
(you become a Contributing Member by donating money to the operation of this site)

  • No ads - advertisements are removed
  • Access the Contributors Only Forum
  • Contributing Members Only Downloads
  • Send attachments with PMs
  • All image/file storage limits are substantially increased for all Contributing Members
  • Option Codes Lookup
  • VIN Option Lookups (limited)

Pavelpu27

Members
  • Content Count

    3
  • Donations

    $0.00 
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Pavelpu27

  • Rank
    Member

Profile Fields

  • From
    Pilsen, Czech Republic
  • Porsche Club
    No
  • Present cars
    911 C2S
  1. Hi all, I have a 2005 C2S and when I got the car from previous owner, it had the airbag error 80E8. The manual says the ECU is faulty and needs to be replaced. I took it out and had it reset and loaded with new SW and it works fine since then for more than a year now. The whole operation took two days and I paid $60 to the SW guy.
  2. I have just done the trunk release exchange. Taking the door sill out was easy thanks to the hints described here. But removing the switch module from the sill was real challenge. Forget the picture posted by Loren. I have tried everything and at the end I found the trick. Lay the sill on the table bottom up. Then you need a very narrow screwdriver 2 mm and you need to push it between the hold tabs of the module. There is s little space there. Just push it straight down and it unclips. There are four of tabs, two on each side. Instalation is very easy, just push the new module to the place until it clicks.
  3. Hi all, I have purchased a C2S with airbag light was indicating some issues. On the diagnostic the fault code was 80E8, which Porsche describes as fault ECU, which needs to be replaced. I have taken the ECU located in the bottom behind the center console out and had it reset and new SW loaded. It was done by a car SW enthusiast, not a official garage. The airbags look OK now, the light goes normally off after a check when turning the ignition on. You can save some good bucks here.
×

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.