sp-design

the question to consider is - have you ever taken old film off of a car.   the film on my previous cayman s started to look bad, gray spots and lines.  it is a major league PITA to remove.  i found it best to start by heating it with a hair dryer, then peel one of the corner of the hood loose, then wrap it around a 3/4" wood dowel ... pull evenly and wrap it around the dowel and keep pulling.   that way its a lot easier on your hands and tends to keep it from breaking / tearing into smaller pieces.  didn't spend the money to put it on my 997 when i bought it. 

many thanks kbrandsma ... this looks extremely helpful.  i will tear into the trunk and find the routes you have described.

cheers

scott

white987s ... sounds very reasonable ... especially if there is a way thru the firewall between the inside of the fender and the glovebox.  anybody know this route?

Guys,

i am new to the 997 community as i just purchased a 2011 911s.  previously had a 987c1,   i do a lot of TSD road rally and i need to run a sensor wire from either front wheel well into the car to provide an input signal for a rally computer. 

what i have read so far is that there is a grommet to the right of the battery into the car (thru the firewall).  what i need to find is a way thru the bulkhead either into the trunk interior and / or directly thru the inner fender.  are there any possible routes?  any advice would be greatly appreciated.

thanks in advance

scott

i am having a similar experience ... my 2006 cayman s (6 speed), 67k miles, has a different noise when the engine is under load in 3rd gear or higher.  if i slow down, and don't downshift, as i accelerate, i hear a rattle / buzz ... usually starting around 2500rpm.  when i am cruising at 3000 / 3500, i don't notice the sound.  i do not notice the sound at idle. 

i am wondering if it is a heat shield or something simple.

as far as i know, it is, as the PCM 2.1 is the same throughout ... up until pcm 3.0 was rolled out (not sure when that occured in the cayenne).

i bought mine from my local Porsche dealer w/o specifics to year ... only the part number. i made use of the PCA 20% off coupon at the end of last year. similar price is available everyday from Sunset Imports.

I have read all of the posts regarding this subject on Renntech.org and Planet-9.com as well as other internet forums and discussions with third party manufacturers such as mObridge. I have found one post that was particularly helpful – musclehedz101 on Renntech.org – as a followup to my post titled – “xm / sirius install w/ pcm 2.1 cayenne kit vs. nav-tv sirpor2 vs. itronic” dated 7 November 2010. His post was based for a 997 (2007 C4S) with a cd changer installed. I decided to go with the Porsche Cayenne unit rather than one of the 3rd party vendors. Yes the Porsche Sirius tuner is still available - just not the Cayenne kit ... but it is much less expensive to buy the tuner and the harness without buying the kit.

I should note that I have a 2006 Cayman S with PCM 2.1, Bose and many other options including mObridge ipod / Bluetooth combination unit, however I do NOT have a cd changer, and do not have TPMS. I will give you the disclaimer you that what I have written worked for me – I will caution you to proceed at your own risk.

The parts you will need are:

955.645.280.02 Porsche Sirius Receiver or (955.645.281.02 Porsche XM Receiver)

955.044.900.65 Porsche Harness for Installation (with CD changer)

Single to Dual Sirius Antenna Adapter http://www.tss-radio.com/products/sirius-dual-to-single-antenna-adapter

Sirius magnetic antenna http://www.tss-radio.com/products/search/browning-magnetic-car-antenna-for-sirius

(there are several out there, I chose the Tram ... just make sure its made for Sirius, unless you are installing XM).

I would recommend that you contact Jeff at Sunset Imports (Renntech.org members know what I am talking about) for the Porsche parts.

I have chosen to mount the receiver on top of the nav dvd unit in the front luggage compartment. I have mounted the antenna on the underside of the cowl (between the windshield wipers). If I run into any interference, I will relocate it above the cowl, but I prefer to leave it concealed if possible.

First remove the cover around the nav dvd player – remove the 8 screws and gently start pulling the front left (passenger side) up, separating it from the perimeter gasket – then carefully unplug the trunk light. It may help to remove the Nav access panels. Next, remove the battery cover and the two side panels. Now is a good time to unplug the battery and remove it. Next, you will need to remove the cowl (if you are going to install the antenna on the underside). The first step is to remove the plastic caps covering the nuts on the windshield wipers, then remove the bolts and the wipers (simply pull them toward you – be careful not to drop it on the hood). Pull the plastic pin rivets from the bottom braces (behind the battery), disconnect the electrical connections for the washers and the water supply. Remove the caps on either side and remove the 10mm nuts and the torx screw at the middle top. Then carefully pick up the cover and reach underneath (on the passenger side) to disconnect the NAV antenna (pull off) ... then gently remove the cover (it may take some gentle “back-and-forth” moving). Mount the antenna next to the NAV antenna and route the cable toward the trunk side. Reinstall the cover at the windshield, reattaching all that you disconnected for the cowl removal. Leave the battery DISCONNECTED.

Next its time to connect the power and the fiber harness. This is much easier and quicker with the factory harness since it has connections to receive the power and fiber optic connections that powered the NAV drive and connect them back to the NAV and then connect to the Satellite tuner.

1. Disconnect fiber cable MOST connector from the back of the NAV drive. (It may be easier if you remove the NAV drive). Be careful with the fiber cable not do damage the end or kink the cable. When you remove the fiber cable from the back of the NAV drive, you will notice that it looks different from your new harness – that is because the new cable has protective ends that must be removed.

2. Plug the MOST Cable into one end of the new Fiber Harness (on the “Y” end), and plug the other end (of the “Y” end) into the NAV drive. Now connect the long singular end of the Fiber Harness into the back of the Satellite tuner.

3. Locate the CD changer power supply cable on the far left (passenger side) of luggage compartment. Connect the power from the “Y” end of the power cable to the CD changer power cable. (if you have a CD changer, then disconnect the power supply and connect the harness – then connect the other power end of the “Y” end of the harness into CD changer).

4. Now connect the long singular end into the back of the Satellite tuner.

5. Plug the antenna adapter to the back of the satellite tuner. The dual leads must be connecting to the corresponding tuner leads – white goes to green (terrestrial lead) – gold goes to brown (satellite lead). I had to cut off the gold cover to get it to fit onto the tuner.

6. After everything below is completed and the tuner is mounted, you will need to manage the excess cable with cable ties as well as secure the antenna adapter.

It is now time to route the antenna cable into the luggage compartment. The best path is thru the rubber grommet. Once routed into the compartment, plug antenna cable into single end of antenna adapter. I chose to mount the tuner to the top of the NAV drive with Velcro ... you could use double stick foam tape.

Reconnect the battery and test the installation prior to reinstalling the panels. To access the Satellite function, turn on the PCM and press the “AM/FM” button – cycling through the modes until you see the satellite radio function appear. If “Satellite” doesn’t appear, you will have to have your dealer program the PCM to acknowledge and recognize the OEM tuner has been added into the network. Mine came right on without needing to get the PCM reset.

Next you will need to contact your satellite provider (Sirius or XM) to activate the tuner. You will need the serial number on top of the tuner. Make sure the radio is on when you call to activate.

Hello All,

A few months ago I completed my Porsche (90%) OEM Sirius Satellite Radio install in my 07' 997 C4S Cab. With work and summer family vacations/activities/etc... I had to postpone documenting my install as a DIY. Well I finally got the time complete the document.

A big thank you to Ric at Suncoast for all of his help and patience with my "science project"... ;-)

As the document is too larger (due to pictures) I have posted it for download (for free, just wait it out for a few seconds) at the following site:

Download DIY Link:

http://rapidshare.com/files/42279771...io_Install.pdf

__________________

2007 C4S Cab (Artic Silver/Black), 6-Spd

CDC, Dension GW500 (iPod), Tooki (BT), Nav, Bose, V-1, OEM Porsche Sirius Satellite Radio

"You gotta respect the Porsche" (Adam Sandler)

i think there is an error in your parts list. part #955.647.117.01 comes up as "navigation antenna s". is the correct part # 955.645.280.02? can you post all the specifics of the actual part ... who made it, and their part number? can't quite read the photo.

many thanks for your fantastic post!

scott

check out - http://www.superbrightleds.com/

also be sure to read some of the cautions on red lights for red lenses.

The Retail Parts Price Search feature (for our Contributing Members) has been updated to reflect July 2010 retail pricing for the US. Yes, this one is a little late. We try to update this on a monthly basis as the price lists come available to us.

For July 2010 the parts price list support:

US: 246,569 parts

Thanks again to Contributing Member Porschelibrarian!

Edit - there was an error in the price list which has now been corrected. Sorry for any inconvenience.

I was wondering why the prices seemed so much lower than my dealer was quoting, and even lower than i was getting from Sunset. i must admit, i wish the old list was real ... this is a huge difference.

scott

many thanks!

but that part number includes tires ... isn't there a part number for the wheels without tires? what if you only needed 1 wheel?

Anybody know the part number for the Carrera Sport or Carrera S2 wheel for the Cayman? i tried to get a price from Sunset - and the only thing they could find was the wheel / tire package. i already have a brand new set of Bridgestones on my Carrera S wheels - just thinking about a new look.

many thanks

scott

They are all listed (with photos) in the Summer Tires and Wheels TSB for the Cayman... http://www.renntech.org/forums/index.php?app=downloads&module=display&section=download&do=confirm_download&id=949

I have read a lot about the reasonably successful installs of the Cayenne kit in sports cars w/ pcm 2.1. i am first curious if anybody has tried the nav-tv sirpor2 (sirius) section or the itronic xm section? and what they think about it compared to the Cayenne XM kit?

i am about to put a mObridge bluetooth / ipod combo in my 2006 cayman s ... and put in satellite radio at the same time w/ both working through the pcm. i wish mObridge had their XM kit complete - but they are only in beta testing ... and apparently thats been going on for a while. i haven't read anything about the itronic unit ... but similar issues with the nav-tv unit - in regard to losing the channels, and draining the power of the battery (similar to the nav-tv tooki bluetooth).

yes this is the expensive way to go, but its cheaper than a 2009 or 2010 car ... and i want to keep my car looking original.

many thanks for your insight

scott

Anybody know the part number for the Carrera Sport or Carrera S2 wheel for the Cayman? i tried to get a price from Sunset - and the only thing they could find was the wheel / tire package. i already have a brand new set of Bridgestones on my Carrera S wheels - just thinking about a new look.

many thanks

scott

I know this thread has been around for a while, but i have a question on which Cayenne kit you installed, there is a kit for a Cayenne with a cd changer - 95504490268, and another for the Cayenne without a cd changer - 95504490267. the reason i ask it that i want to put xm into my 2006 - 987 Cayman. and i'm not sure if there is a better option than the Cayenne kit.

many thanks

scott

Ok, got the XM installed fine and it works... mostly. About 35% of the time, I start the car and the radio is on the last station but my channel list is empty, it doesn't display the current channel info, and I cannot change stations! If I take the key out for 15-20 seconds and restart the car, all work as normal.

Also, if I hit Main + Trip to pull up PCM versions, it has a triangle with "!" next to satellite. Dealer hooked it up to PIWIS today. It said said bad module for sat, but tech said that was fine since the Cayenne kit wasn't made for 997. Ultimate advice was "Sorry, probably software bug. Live with it."

Any ideas?