towny

Can anyone help?

The rear of the car feels like the backend is about slide-out when cornering

I have new tyres on the rear and I have just replaced the anti-roll bar bushes all round

But I did notice when fitting the rear bushes that roll bar moved very freely as if the bushes where to

Big but I measured them and they were the same as the old ones

thanks for the info

they are after market

Thanks Loren

Carried out the checks and the readings seems to be fine infinite ohms and 456mv and 717mv

But still getting P0131 and P0151 codes

Any further thoughts

Can anyone help?

I know there have been several posts on this

I have the following fault codes

P1602 Supply voltage Open circuit

P0131 O2 sensor ahead of cat. conv. Cylinder (1-3)

P0151 O2 sensor ahead of cat. conv. Cylinder (4-6)

P1115 Heating power O2S ahead of cat. c. bank 1

P1119 Porsche fault code Heating power O2S ahead of cat. c. bank 2

I have replaced both Lambda sensors but the fault codes are still been thrown up

I’m getting a constant Lambda reading of 1 and a minus voltage reading on both sensors

Is this correct

Loren has replied to a previous post to check the following

Things to check:Short circuit in signal wire to ECM ground or housing ground.Short circuit in signal wire to ECM ground or housing ground.DME control module output stage short to ground.Possible causes:- Wiring harness- Oxygen sensor- DME control module

According to the explanation of the codes it’s a Type 3 Short to ground/below lower limit/lean mixture threshold

My question is how do I test for the above?

I would be grateful for any guidance