coleta

We care. Keep us updated. Hope it works out for you

Tool pants, which button is missing on the 2 button remote, for the rear lid release? Is this the case with ALL 97-00 cars? And lastly, what's different in 97 that wouldn't allow the 3 buttom set up?

Thanks

Thanks

Good to know. Thanks

thanks

deilenberger, where did you shine the light? To the coupler or into the actual fiber optic harness of the car?

Cloudsurfer, does this mean you wouldn't have high beams?

Whall, where's this display and reset found on the tools?

I randomly see these. like this one - 62256 90880.

I know what M numbers are, but what's this about. Thanks

Maurice, how do you reverse the motor direction with this switch? Say you're opening the top with the button depress, do you simply toggle the metal reed on the switch and all of a sudden the top starts to close?

Thanks

Thanks, and sorry to hear about all of this.

can you post the emissions test?

Thanks. Best site in the world.

Hi Loren,

why would an engine replacement show lower hours in the dme than in the airbag?

me too, me too :jump:

Anybody know what type of spring compressor is being used in this DIY? It's nice. Or can someone recommend one, maybe post pics of tool? Thanks

Loren, how would you go about getting motorsport part number?

Hi Todd, sorry about this but I can't find your reference. I looked under On-board Diagnistics 5.2.2. The pages are identified by letters and then the page number for that letter section. After these letter sections the pages are then identified by the actual fault code.

My section D ends with page 8:

And has nothing to do with vario cam.

What am I doing wrong?

Thanks

Hi Maurice, just making sure you didn't miss this one. Thanks

bump

I think I see what my confusion is. Your saying that when the cam advances both actual values, that of camshaft deviation AND actual angle for camshaft, will show 25 degrees?

And thanks for the reference.

Maurice, just wondering what supported your above conclusion. Thanks.

The reference explains the 25 degree advance but also says this:

So the 25 degree reference here is for deviation. Can you post your info or give the section were it's found?

Thanks Tholyoak

tholyoak, you mentioned the deviation spec. is +/- 6 degrees. Where did up get this spec from? I found an old Porsche workbook that shows it at +/- 25, believe it or not. I'm gonna try and scan it so I can post it.