Vwshotta

No I don't but it's a common pump Toyota and many other trucks use the same Tranny

Sent from my iPhone using Tapatalk

Hi,I have exactly the same issue. Did you solve the problem? I did all the checkings, tested it with durametric, changed fluid and nothing. Dont want to throw out transmission which is maybe good. I'm out of ideas, valve body - maybe but until this happened no issues with trans at all.

Sent from my iPhone using Tapatalk

I recoded the ecu and the same Cade and truck still won't engage in gear should I change the valve body

Hi guy I changed the ecu today do anyone have the programming instructions to re-syncing it to the truck or can I just plug it up and clear any code

Hey guys I finally got some time to check out the truck I checked all connectors at the tranny and they are all in good condition no corrosion and all well connected I further proceed to go under the pass seat directly at the TCU and verified all connector and all is well also and I have continuity ,I scan the car again and the same code come up p0721 ,what should I do next or what step to take ,Thanks again for the great help ,greatly appreciated

@royxaxa thank I'll do that and I'll update my results thanks for your help

Thanks guy for your input ,tomorrow I'm going to check all wiring and connectors and take it from there ,I'll post up my progress

@loren do you have part #and procedure in replace

I changed the sensor and it didn't change and I cleared the code and still nothing

While driving home stoped to put gas drove off fine ,stop really hard at the stop light till the abs kicked in when I took off the truck took off fine 2 seconds later it felt like it's in neutral and engage and run neutral again now it not moving and I try manual mode and still nothing I tried resting the battery and it still doesn't move and I can select gears PRND selected I scanned it and got code p0721 output sensor ,I ordered the part and changed it and still I got the code and still nothing have anyone ever have similar problem or have any idea ware greatly appreciated ,THANKS IN ADVANCE

I was able to make an adapter to get the vagcom to work and I get this code and erase it and it comes right back not sure where to go from here I also notice I can't lower or raise the truck .thanks again

I have vag.com but it doesn't read the suspension it only reads the engine

Hi all I new to cayenne bought the truck a few months back ,fix all back up so far great truck , every time I start the car air suspension fault workshop,I've done the compressor piston ring and still I get the code on the selector inside It shows the different selection in the cluster but it doesn't raise or lower sometime I drive the back bouncy around real bad and rides horrible I don't have access to durametric so idont have any codes .thanks