Welcome to RennTech.org Community, Guest
There are many great features available to you once you register at RennTech.org
You are free to view posts here, but you must log in to reply to existing posts, or to start your own new topic. Like most online communities, there are costs involved to maintain a site like this - so we encourage our members to subscribe or donate. All subscriptions and donations go to the costs operating and maintaining this site. We prefer that guests take part in our community and we offer a lot in return to those willing to join our corner of the Porsche world. This site is 99 percent member supported (less than 1 percent comes from advertising) - so please consider an annual subscription or donation to keep this site running.
Here are some of the features available - once you subscribe RennTech.org
- View Classified Ads
- DIY Tutorials
- Porsche TSB Listings (limited)
- VIN Decoder
- Special Offers
- Paint Codes
- Registry
- Videos System
- View Reviews
- and get rid of this welcome message
It takes just a few minutes to register, and it's quality Porsche information at a low cost.
Contributing Members also get these additional benefits:
(you become a Contributing Member by subscribing or donating money to the operation of this site)
- No ads - advertisements are removed
- Access the Contributors Only Forum
- Contributing Members Only Downloads
- Send attachments with PMs
- All image/file storage limits are substantially increased for all Contributing Members
- Option Codes Lookup
- VIN Option Lookups (limited)
Search the Community
Showing results for tags 'engine error'.
Found 1 result
-
I hooked up my Durametric cable on my 99 C2 cab the other day. I checked the engine error codes section. Error P1531 - (Camshaft Adjustment Bank 1). This was not here the last two times I checked. Actually the only two times I checked. No CEL light on the dash though. I cleared the code and drove it another day. Same error on Durametric but again no CEL light. Does the CEL light have a certain threshold (ie error code persisting for xx seconds or something) before lightning up indicating an issue? The car seems to idle and run up fine. I googled and they said check the wiring harness to the solenoid & actuator. Where is this? I have the Bentley book but could not fine where it mentioned the Variocam actuator and electrical connector. Any suggestions? Thanks Jeff