Welcome to RennTech.org Community, Guest
There are many great features available to you once you register at RennTech.org
You are free to view posts here, but you must log in to reply to existing posts, or to start your own new topic. Like most online communities, there are costs involved to maintain a site like this - so we encourage our members to donate. All donations go to the costs operating and maintaining this site. We prefer that guests take part in our community and we offer a lot in return to those willing to join our corner of the Porsche world. This site is 99 percent member supported (less than 1 percent comes from advertising) - so please consider an annual donation to keep this site running.
Here are some of the features available - once you register at RennTech.org
- View Classified Ads
- DIY Tutorials
- Porsche TSB Listings (limited)
- VIN Decoder
- Special Offers
-
OBD II P-Codes - Paint Codes
- Registry
- Videos System
- View Reviews
- and get rid of this welcome message
It takes just a few minutes to register, and it's FREE
Contributing Members also get these additional benefits:
(you become a Contributing Member by donating money to the operation of this site)
- No ads - advertisements are removed
- Access the Contributors Only Forum
- Contributing Members Only Downloads
- Send attachments with PMs
- All image/file storage limits are substantially increased for all Contributing Members
- Option Codes Lookup
- VIN Option Lookups (limited)
DarrylZ
-
Posts
1 -
Joined
-
Last visited
DarrylZ's Achievements
Member (1/1)
0
Reputation
-
I have a 99 Boxster Base LHD 2.5L with a new top with window and replaced all the parts in the storage box area including cables, rails, arms, transmissions to the newer version and the top works great as it should when putting the top up in closed position. Clamshell fits flush with the body without issue. When putting the top down the clamshell sits up about an inch or so from fitting flush and the top light stays lit in the dash because it isn't going down enough to shut off the sensor switch. I have tried adjusting the length of the pushrods both at the 10mm bolt on the arm and adjusted the plastic ball joint caps farther out and closer in to see if this would hep reduce or eliminate the gap between the clamshell and the body. I have measured the ball joints on the boomerang arms to 195mm to the storage box rubber gasket as a reference point to assure the transmissions are synced. I am at a loss as to what needs to be adjusted in order to close the clamshell when top is down. Anyone able to help me figure out what needs to be adjusted??