erey

It is more likely a bad regulator than an adjustment.

Either way the inside door panel likely needs to come off for inspection or adjustment.

Thanks Loren

today i removed the plastic cover on the bottom of door and with the windown down you can see the torque screw adjustment my window operates OK the issue is compare to other door the travel going up close pos is a bit to much can this adjustment take care of .200 to .500 inch?

thanks

ER

Have you tried this:

Storing end position of the windows

If the battery is disconnected and reconnected, the

windows will not be raised automatically when the

door is closed.

1. Close the windows with the rocker switch once.

2. Press the rocker switch upwards again to

store the end position of the windows in the

control unit.

No the issue i have is a little over travel in the close position and i need to adjust the end travel / stop limit i know there are adjustments torqs in the bottom of the door but i need some guidance as to how to proceed to adjust

Loren if you can please give me some guidance

tthanks again to all

ER

I need some help on how to adjust the up travel (close) on the drivers window, is traveling about .300" more than the passenger side and its making a clicking noise once it reaches its travel as compare to the other door. i beleive there are some kind of adjustment on the bottom of the door but i would like to confirmed. car is a 2007 997.1 S

Thank you all in advance

ER

ER,

No problems with balance. Unfortunately, I don't have TPMS on my car. I'm in Palm Beach County, and used Ernie Bello's Motorsports in West Palm Beach. Ernie's a nice guy and weekend racer so he understands Porsches, but I'm sure you can find somewhere closer. I had my intermediate shaft bearing replaced at J&W Motorsports in Doral. They specialize in Audis and Porsches so you could call William at 305-450-7726 and ask him who he recommends. Good luck.

Thank you again

ER,

To offer an opposing view, I also read the negative posts. But I also decided not to judge a company based on one transaction. So after not finding many other complaints, I ordered the 808 series in 19" with Hankook tires. To hedge my bets, I charged the purchase to my credit card. The whole transaction could not have been handled better and the wheels and tires arrived without incident. I initially chose center caps in black and silver but after I got the wheels I decided I wanted the colored center caps. They agreed to exchange them for no charge.

I will admit that I had a problem with some of the wheel weights falling off after I drove the car, but the company's view is that they provide the balancing as a free courtesy so the buyer can't hold them responsible for something the buyer didn't pay for. So I had to have the wheels (re-) balanced. Otherwise, I am very pleased. I've had the wheels and tires for about 5 months now and haven't even had to add air. I have no affiliation, as I'm on the opposite side of the country (FL.) from Wheel Dynamics. Here's the thread I posted after getting the wheels:

http://www.6speedonl...lebee-look.html

Please feel free to contact me if you have specific questions.

Jeff

Thanks Jeff

Sorry for the late reply, have you had any issues with balancing and with the TPMS readings

I am in the south dade area who are you using for service / balancing etc

best regards

ER

Yes, both cars share the same fundamental engine and exhaust.

Thanks Loren looks preety straight forward have the car up on lift / ramps wheels off, tools require and time

Helo

I have a question regarding the instructions for 996 spark plug replacement will this procedure be the same for 997.1S?

Thanks in advance

ER

I been thinking on getting new wheels for my 2007 C2S Black on Black and this site seems to have a good varirety of wheels to choose from so i have a few questions:

As a company and customer service how are they

...

ER

ER:

There was a very long thread on Rennlist.com about a year ago. You should do some reading before making a decision on where to put your hard-earned $$: http://www.6speedonl...must-see-5.html

I have no personal experience with them, but I was taken aback when that particular incident happened. I do know that Wheel Dynamics is not banned from Rennlist, probably as a result of that incident. Anyway, do some more searching so that you can make your own decision.

Regards, Maurice.

Thank you Maurice

Its amazing what you can find out thru this forum and other P forums

Back to the drawing board on searching for a decend set of wheels from a good service provider

Best regards

ER

I been thinking on getting new wheels for my 2007 C2S Black on Black and this site seems to have a good varirety of wheels to choose from so i have a few questions:

As a company and customer service how are they

Are any you guys / gals running the followimg wheels 808 series monoblock 19", Victor Innsbruck, Vertini magic and last one Avant Gaede.

Any issues witht the TPMS

Any weigh issues and oveall quality of the product

if I miss anything else I would need to know please add comments

Thanks in advance

ER

I will like to thank everyone in this forum for all the DYI and other topics, it is a world of information that can help anyboby feel confident on owning and maintaning these wonderfull cars.

i have a question regarding the air box removal to gain access to the filter, i follow instructions on disconnecting the mass air flow connector and the other sensor adjuacent to it (no problems) however there is another sensor in the bottom of the air box with a thin cable that attaches to a two way connetor via a plastic connector to the box from this point the thin cable continues to and thru the top of the engine (passager side) this connector has anothe connector that can be disconnected by pulling a metal keeper. how can you disconnect the bottom sensor to be able to take the entire air box out.

Thanks in advance

car is a 2007 911S 2 wd

ER