Welcome to RennTech.org Community, Guest
There are many great features available to you once you register at RennTech.org
You are free to view posts here, but you must log in to reply to existing posts, or to start your own new topic. Like most online communities, there are costs involved to maintain a site like this - so we encourage our members to donate. All donations go to the costs operating and maintaining this site. We prefer that guests take part in our community and we offer a lot in return to those willing to join our corner of the Porsche world. This site is 99 percent member supported (less than 1 percent comes from advertising) - so please consider an annual donation to keep this site running.
Here are some of the features available - once you register at RennTech.org
- View Classified Ads
- DIY Tutorials
- Porsche TSB Listings (limited)
- VIN Decoder
- Special Offers
OBD II P-Codes
- Paint Codes
- Videos System
- View Reviews
- and get rid of this welcome message
It takes just a few minutes to register, and it's FREE
Contributing Members also get these additional benefits:
(you become a Contributing Member by donating money to the operation of this site)
- No ads - advertisements are removed
- Access the Contributors Only Forum
- Contributing Members Only Downloads
- Send attachments with PMs
- All image/file storage limits are substantially increased for all Contributing Members
- Option Codes Lookup
- VIN Option Lookups (limited)
Phunboy replied to bberryj's topic in 997-1 Series (Carrera, Carrera 4, Carrera 2S, Carrera 4S)Yep, I had the same P0441 CEL on my 2006 997.1 with the hard start after every fuel fill up. The culprit is a bad purge vent valve. Depending on the engine, I had M96 engine, I had to replace with part 99711012801. Best price was from ECS Tuning. The valve replacement is a 5 minute job... it's right above the alternator, on the top left once you open the rear engine hood. Good luck!
Phunboy started following 997-1 Series (Carrera, Carrera 4, Carrera 2S, Carrera 4S)
Thanks for the warm welcome JFP. Would you have a part number or description of the defectivecontrol unit or switch in the top latch assembly? And would the control unit or switch cause one window not to roll up?
Hi fellas, I have a MY 2006 c2 cab and noticed my passenger window will not one touch roll up. I also discovered my window will drop 1cm when opening the door, but will not roll back up when the door closes. Both inside and outside handles will drop the passenger window, but will not roll back up. Question: Is the one touch roll up directly affected by this microswitch issue? And which microswitch do I need to replace? There are 3? Many thanks members!!