Jump to content

Welcome to RennTech.org Community, Guest

There are many great features available to you once you register at RennTech.org
You are free to view posts here, but you must log in to reply to existing posts, or to start your own new topic. Like most online communities, there are costs involved to maintain a site like this - so we encourage our members to donate. All donations go to the costs operating and maintaining this site. We prefer that guests take part in our community and we offer a lot in return to those willing to join our corner of the Porsche world. This site is 99 percent member supported (less than 1 percent comes from advertising) - so please consider an annual donation to keep this site running.

Here are some of the features available - once you register at RennTech.org

  • View Classified Ads
  • DIY Tutorials
  • Porsche TSB Listings (limited)
  • VIN Decoder
  • Special Offers
  • OBD II P-Codes
  • Paint Codes
  • Registry
  • Videos System
  • View Reviews
  • and get rid of this welcome message

It takes just a few minutes to register, and it's FREE

Contributing Members also get these additional benefits:
(you become a Contributing Member by donating money to the operation of this site)

  • No ads - advertisements are removed
  • Access the Contributors Only Forum
  • Contributing Members Only Downloads
  • Send attachments with PMs
  • All image/file storage limits are substantially increased for all Contributing Members
  • Option Codes Lookup
  • VIN Option Lookups (limited)

Amp install questions


Recommended Posts

I recently installed an amp in my trunk/bonnet and I'm getting some alternator whine/buzz.

Couple questions for those who have installed aftermarket amps:

- Where did you run the RCAs through the fire wall ?

- Where did you run the RCAs through the 2nd wall (btwn storage area and battery compartment)?

- Where did you ground your amp?

Thanks!

Link to comment
Share on other sites

I grounded my amp to the post with the bolt head at the very bottom of the trunk where the original bose amp was bolted to the floor.

I rank a 4awg firewall grommet for the amp so that its theres is nothing "signal" related within within 4 inches.

In term sof wire routing - After several tries I did the following:

Ran RCA using a fish tape straight through the firewall grommet behind the battery.

- its important that these wires do not drop down in the dash.

- if you look closely in the drivers side near the center console by your gas pedal...you will see a shiny black cable that is wired tied to the console.

(This is actually a mains power line) its seems to be the problem most people have - anything with a signal that its close to this will pick up noise...

Those wires then come stright forward and make a turn and are routed in front of the battery, they then go towards the passenger fender and through the existing wire loom using a hole that you have to make above the other wires installed in it.

As for the head unit - it is hot wired to the battery directly and grounded there as well.

The ignition wire is tapped for turn on/off when the key is inserted.

I used power line filters on the head unit positive and ignition.

The hot and ground wirews from the head unit go through the grommet closest to the drivers door.

If you look under your dash on the drivers side you can see where that grommet runs existing wires.

Its up on the firewall behind the fuse panel and clutch.

Good luck

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.