Welcome to RennTech.org Community, Guest
1999 986 2.5 Boxster. (5 spd)
Not many problems with the car but cruise control doesn’t work and the spoiler only extends halfway or so.
Current actual problem with the car is that I can feel vibration or shaking in the steering wheel (and in the car to a much lesser extent) after shifting into fourth gear. After shifting into fourth gear, the shaking seems to persist even as I slow down, or after shifting into fifth. It will persist even if I shift into neutral but will stop after I come to a stop.
It’s strange to me that this is the case when gears 1-3 don’t have this problem. I am guessing that it’s an issue with bearings or alignment in the front wheels since i’m feeling the vibrations in the wheel but hopefully someone here has a better idea.
Tried googeleing it but couldn’t find what I was after. Was curious if anyone knows what type of flat 6 the 986 boxster has?
Is it a a true boxer engine? Or a horizontally opposed flat V? True boxer meaning it has individual crank pins for each piston and is a true 180degree angle. Thanks in advance
I'm new to the Porsche family.... Just over a month and the proud owner of a 1999 Boxster. It's a project car but still on the road and my point to point ride. Must say, LOVE to drive this car....This one has been lowered some, well alot... and does it hug the road..... Just doesn't miss much being that low.... My question is, I am having an issue with the rear lights on this car... I know I had a problem with the left rear brake light. I tried tracing back the wire but found no problem... I then switched the lamp holder from the right side to the left and all the lights worked... So I thought I had an equipment issue. I bought a (Porsche) replacement bulb holder. Came in last night. Changed out today...Guess what???? Turn indicators work, Backup lights work, Brake light works on the Right Side ONLY, (still) Now no rear tail lights what so ever......I have checked ALL the fuses, only had to replace one and it had nothing to do with the lights. NOTHING has changed....Where did my tail lights go?????? Can't figure this out.......Please help.......Just FYI, ALL the LIGHTS were working as of last Wed. when I did the bulb holder swap and checking the lights. Power is to both wire harnesses. Everything else works except the left brake light and the drive lights. Go figure.......
For some reason my front drivers side speaker was going in and out then cut out completely. As a result I swapped out the speaker with another 4" speaker. I kept the existing plug and cut everything else out. I used the ring from the original to hold it down, but I cut small slots for the new speakers feet. Here are the photos but I did not make many notes.
After I install the speaker I noticed that it did not work but did work with volume turned up high. I tested it with the other front jack before soldering it all together. I also add a dab of plastic glue on sides since there was no screw. I had a hack saw but did not use it. The mini dremel was cool.
It might be worth noting that the red and yellow wires on the head unit needed to be reversed despite the diagram. Just look at the Crutchfield website and you will see it. I also swapped out the radio. I am going to sell it. It was a CDR-210. I am suspecting that my problem is the amp and that particular channel. Forgive the pictures I had shared it on my Facebook Story lol ?