Welcome to RennTech.org Community, Guest
By Tj 27
I have a 2009 957 3.6l v6 Cayenne. The battery was dead a few days ago so I replaced it. It now starts up just as it should but when run a diagnostic it says the alternator voltage is high reading 14.72. I’m assuming I need to replace the alternator to remedy this. I can’t find any information about replacing the alternator. Has anyone attempted this? It looks like it might be straightforward but my concern is whether or not the intake manifold has to be removed in order to get clear access. If anyone has any insight on this I would greatly appreciate it.
My 1999 911 Carrera started smoking at a streetlight. Very smelly blue smoke was coming from under the engine cover. I pulled over and popped the cover. Blue smoke was coming from somewhere under the engine (not the exhaust). The engine stopped very suddenly.
We don't have a local Porsche dealer, but the Subaru dealer owns a bunch of 911s and he has a couple Porsche mechanics. I had it towed there.
The C1 fuse ("Engine Electronics") was blown. They replaced it, but as soon as they turned the key, the "cam adjuster wiring harness" (I do not know what this is) began to smoke, and the fuse blew again.
They disconnected the cam adjuster wiring harness (I don't know what this means, and neither did the service advisor), and the fuse stayed intact, and they got the car started. They were able to drive it out to the parking lot with no problems.
They said I need a new cam adjuster wiring harness (again, no idea what this is), and this would require an engine out repair, which they could not do. They estimated this work at $5,000 to $6,000.
Additionally, they did not know how drivable the car was with a disconnected cam adjuster wiring harness.
So ... how bad is this? (Service report image attached.)
Hi everyone, I just got a set of gauges for a 2005 996. I'm building a simulator for PC and would like to wire the gauges to work with racing games. I am in need of the wiring diagrams for the cluster. If anyone has a picture or manual that can help me out it would be great! Looking for inputs, power, signal.
Does anyone have a wiring diagram for the seat on a 2008/957 Cayenne which they can let me have?
I’m trying to chase a fault where the passenger seat will motor up and down and the backrest will adjust forward and aft, but there is no response from the controls to move the seat unit forwards and backwards, or the four-way lumber support control.
Thanks in anticipation...
My front wheel was making a rattling noise for about the last week, and this morning as I drove out of my driveway and turned the wheel, I could hear a loud popping noise coming from my wheel whenever I turned. My best guess is that I drove over a pothole and the control arm / bushing moved out of place. Would this be covered under the OE warranty? Or should I take it to a mechanic?