Server Lease Renewal/Software Licenses
Our yearly server lease, software licenses, as well as hardware operating costs, ARE due Dec 6th, 2021. Our current donations have fallen far short of the funds we need to renew. Please remember the RennTech.org community is Member supported so please consider a donation to help... THANK YOU!
Welcome to RennTech.org Community, Guest
By Mike Blaszczak
I have a 1999 C4 coupe with a manual transmission. Earlier in the spring, I had the transmission repaired -- 2nd gear replaced and the pinion bearing replaced, too.
Since then, I installed a short-shift kit myself.
Today, I noticed that the back-up lights aren't illuminating. All the gears engage fine, including reverse, so I don't think there's an adjustment problem. I don't know if the lights were working or not before my short-shift installation.
What are the likely causes for the lights not working? Switch wasn't reconnected after tranny work, or the switch is bad, I guess. But could my short-shift installation be causing the problem?
By Amber Wells
I have a 97 tiptronic non turbo boxster. I blew my front seal so I need to rebuild my tranny. I just need to know what the parts numbers are for the bushing and seal.... I cant seem to find em and want to make sure I order the right parts.
I heard you can actually order a larger bearing and seal and then machine out the tranny where it goes into and in turn avoid this sort of issue for much longer.. if that helps identify what im needing here im sorry im sort of lacking in the lingo im still learning and will update with a better description once i can go over it again with the boyfriend.
My 2001 C4 Automatic had what appeared to slip (over rev) when making scarp turns, decided to replace transmission filter and refill, the first run after 10 minuets the transmission went into limp mode (lights on drive selector started to flash) check engine lamp came on (P0734 and P0734) was read. the reason given was input and output ratio wrong for both codes.
The Durmatic gave no other info. So I proceeded to order both input and output sensors. Since I couldn't confirm if a shift selonod was bad. Mean while I am in Cal for the holidays I remembered I moved two of the magnets in the pan there were 4 magnets 2 each in the depressions in the rear of the pan I took one each and moved the forward closer to the input and output sensors.
Anybody out there have any idea besides taking it to the dealer, at 75 bucks for the 5 liters of tranny oil each time I replace something to help me be smarter?
After 18yrs my convertible top has finally encountered its first issue. After using this forum (thank you!!) to figure out how to access all of the components (top was stuck in closed position), I found the root of my issue, a bad cable. However, as I was very carefully removing the cable from the transmission, the "clip" which is molded into the plastic cover cracked and is no longer functional (see image). Not really surprising on an 18yr old piece of plastic. The transmission works perfectly and I do not want to replace it, so I am looking for advice on any other ways that I can keep the cable properly engaged to the transmission. Please let me know if anyone else has encountered this and if there are any viable solutions. Thank you!
I recently changed my transmission with a used one I bought online.
After picking up from the shop which was about 2 hours away the truck drove fine while on highway but once i got off the highway and came to a stop the truck wouldn't accelerate. I hit the gas and for about 3-5 seconds it didn't go anywhere and then all of a sudden it kicked in to gear. When i drive it with the tip-tronic it seems to be fine until I come to a a complete stop.
I read on a different forum that someone was having the same issue and got some software updated but unfortunately doesn't say what the update was and it's a post from 2013.
Any help will be greatly appreciated. I really like this car i purchased a couple months ago.